GB
INSTALLATION
Unpacking
All transit bolts at the rear of the appliance and packing must be
removed before using the appliance.
Keep all packaging away from children.
Keep all the transit bolts for re-use in case the appliance is to be
transported again.
Positioning
Install the appliance on a flat hard floor.
Make sure that there is sufficient space for air circulation around the
appliance.
Do not install the appliance on a carpeted floor.
Levelling
Level the appliance by raising or lowering the feet.
Loosen the lock nut using a spanner (not supplied) and turn the foot by
hand until it contacts the floor.
Hold the foot with one hand and fasten the nut against the cabinet with
a spanner.
Never put cartons, wooden blocks or similar materials under the machine
to balance the irregularities on the level of the ground.
Accurate levelling prevents vibration, noise and displacement of the
appliance during operation.
Water inlet
Screw one end of the inlet hose on the back of the appliance.
The appliance must be connected to a cold water supply.
Connect the other end of the inlet hose to a tap with a 3/4” thread.
Water drainage
To plumb in the appliance, please use one of the following methods.
1.Push the hose firmly into a drainage standpipe.
OR
2.
Connect the drain hose onto a sink outlet spigot securely.
Min.60cm
Max.100cm
27
Electrical connection
Your washing machine works with 220-240V and 50Hz.
Electrical connections must be carried out by a qualified technician in
compliance with the current safety regulations.
Your washing machine must be properly earthed. We will not be held
responsible for any damage that may occur as a result of usage without
correct earth connection.
Do not use extension leads or multi-sockets.
Notes:
Make sure that the water discharge hose does not bend, buckle, is not crushed or extended.
The water drain hose should be mounted at a height of minimum 60 cm, maximum 100 cm from
the ground.
Downloaded from www.vandenborre.be
