P10
maInmEnU
7.1.1satellitesettings
Use this menu to change the settings for a given satellite and to configure the parameters
for the used antenna Use
pq
to highlight
Satellite
and
tu
to set the satellite you wish to
change the settings for. To see a list with all available satellites, press
ok
when the highlight
is on
Satellite
. Use
pq
to highlight
Transponder
and
tu
to set the desired transponder.
Signal bars indicating signal quality and strength can be found on the bottom of the screen.
These bars show the signal conditions for the chosen satellite and transponder. You can now
adjust the following settings:
LNB
type
,
LO
Frequency
,
LNB
power
,
Band
(
22kHz
),
Switch
Type
,
Switch
Input
,
Antenna
Mode
and
Antenna
Position
. Once all settings are made, press
EXIT
to get to the previous menu or use
pq
to highlight
Go
To
and
tu
to select
Auto
Scan
or
Manual
Scan
to advance to
Auto
Scan
or
Manual
Scan
.
A confirmation banner will now be displayed. Press
ok
to confirm the made changes or
EXIT
to discard.
7.1.2autoscan
Use this menu to perform an automatic channel search on one or more satellites.
On the left of the screen, a list with satellites is displayed. Use
pq
to highlight the satellite(s)
you wish to scan and press
ok
to mark the highlighted satellite. Press
ok
again to unmark a
marked satellite.
noTE:
you can mark multiple satellites. Auto Scan will search all marked satellites for
available channels.
Now select the desired scanning options on the right of the screen. Use
u
pq
to highlight
and
ok
to set an option.
Scan Mode:
All
: scan all channels,
Free
: scan Free-To-Air channels only,
Scrambled
: scan scrambled channels only.
Service Type:
All
: scan TV and Radio channels,
TV
scan TV channels only,
Radio
:
scan radio channels only.
Network Search:
Disabled
: no network search,
Enabled
: network search will
be performed.
Once all settings are made, press the
gREEn
button on the remote control to start the scan or
EXIT
to quit without scanning.
All newly found channels will be stored at the end of the channel list.
TIP:
Network Search: If Disabled is selected, the receiver will search only for channels available
from the preset transponder list of the selected satellite. If it is set to Enabled, the receiver will perform an
additional search for channels from the NIT table (NIT= Network Identification Table). Use this option to receive
new launched channels from the selected satellite.
7.1.3manualscan
Use this menu to scan a single transponder only.
The following can be set:
Satellite
,
Transponder
,
Frequency
,
Polarisation
,
Symbolrate
,
Scan
Mode
,
Service
Type
and
Network
search
. Use
pq
to move the highlight to the chosen setting
and
tu
to change its value. Once all settings set correct, press the
gREEn
button to start
scanning or
EXIT
to quit. All newly found channels will be stored at the end of the channel list.
noTE:
If you want to scan for a specific channel only, press YELLOW in the Manual Scan menu
to make settings for a PID search. Scan mode, Service type and Network search will then be replaced by
settings for Video PID, Audio PID and PCR PID. For information on PID values, please visit websites like:
www.lyngsat.com or www.kingofsat.net
