P7
English
QuICkguIdeTousIngYourreCeIver
broadcasts full screen on your 4:3 TV),
4:3 letterbox
(black bars
on top and under the picture on a 4:3 TV) and
16:9
(use this
setting for 16:9 TV sets).
Scan mode:
Select
All
to store scrambled and free to air channels or select
Free
to store only free to air channels. Note: Scrambled channels
cannot be viewed with this receiver.
Connection:
Use this option to adjust the established connection to your TV
set. Select
HDMI
or
TV SCART
.
*Availability of DVB/HoH subtitles depends on the broadcast. If such subtitles are not supported, then most likely subtitles can be
activated via Teletext if available.
When all settings have been made, move the highlight to
ok
and press
ok
to continue.
noTe:
Wrong region selection can lead to missing channels or channels
being stored at wrong positions in the channel list.
The receiver will now advance to the
Aerial Adjustment
screen.
This part of the wizard is of great help when setting up your antenna system.
Use
pq
to move the highlight to the setting you wish to alter and use
tu
to change
values. The following settings are available:
Antenna Power:
Set to
On
if you use an active antenna. When set to
On
, 5 V will
be present at the ANT IN connector of the receiver. Select
Off
for
passive antennas.
Beeper:
Select
On
for an audible indication of signal reception.
Off
turns
the beeper off.
Channel No.:
Select a channel that is known to carry a broadcast in your
region. The
Signal Strength
and
Signal Quality
bars give a
visual indication of the reception. Adjust your antenna to obtain
maximum signal strength and quality.
When all settings have been made, press
ok
to start scanning.
The receiver will search for all available channels now. Once scanning is finished, the receiver
switches to viewing mode.
TIP:
If the
Welcome
menu does not appear after switching on the
receiver the first time, reset the receiver to factory settings by
pressing the
menu
button and selecting
Load Factory Setting
in
the submenu
Tools
.
(defaulTPIn:1234)
.
5.0QuICkguIdeTousIngYourreCeIver
We at THOMSON understand that you can’t wait to enjoy your new high definition
digital terrestrial receiver. The following quick guide will make you familiar with the basic
operation of this device. We do, however, advice you to read the full manual to get the best
performance from your receiver.
To turn your receiver ON or to Standby, use the
q
button on the remote control.
Choose the desired channel with the
pq
buttons. Alternatively, you can digit the channel
number with the
0~9
buttons on the remote control or press
ok
in viewing mode to display
the channel list. The volume can be adjusted with the
tu
buttons.
