USING THE HEATER:
1. Before using this appliance, ensure that it is placed on a flat, stable surface.
This unit is equipped with an anti-tilt device which stops the machine in case it falls down or if it is not
placed on a stable surface.
2. Check that the voltage corresponds to that of the power supply (230V~ mains socket). Plug in the
appliance.
3. This heater is equipped with digital Controls that provide the ability to set the temperature to the exact
degree desired. To operate, simply follow these instructions.
Note
:
The display shows the temperature of the area around the product (diagrams below)
There may be a difference of temperature indication, between the heating zone and the room. This
difference is reduced during a continuous operation of the heater.
Note:
The temperature display will not reflect the accurate room temperature until the heater has been
operating for at least 20 minutes.
4. Place the product in an upright position on a flat, steady, stable, heat-resistant surface. Make sure there is
nothing flammable or heat sensitive within 1 meter. Operating the product in any other position could
cause a hazard.
5. Insert the mains plug into a suitable wall socket. Press
on the control panel of heater or
on the remote control to turn on the product.
To switch off the heater, press again this button and ventilation will continue to operate for 15 seconds to
cool the interior of the unit before it fully stops.
6. Press
on the control panel of heater or
on the remote control to select one of the 4
modes:
Low power:
High power:
Auto:
Frost protection:
▪
In the mode low power
and mode high power
the set temperature can be defined.
Press
to set the target temperature when the display blind.
GB-6