En
gli
sh
9
To open the channel and programme* information, you have to press the
INFO
button in viewing
mode. In this state it is possible to use
t
u
to display channel and programme information about
other channels without switching channels. Press
INFO
twice to display detailed programme
information about the current or next programme. Use
t
u
to change between the current and next
event information. In the respective programme information you can use
P+/P-
to scroll if applicable.
If you press
INFO
for the third time, the corresponding technical details will be displayed. Press
INFO
or to close the information.
* Programme information is displayed when available. Availability depends on the broadcast.
Note:
5 min after switching the receiver into Standby it will enter the deep sleep
mode. Within this time the receiver is able to start up quickly. Starting up
from deep sleep takes approx. 45 sec.
6.0 OPERATION
In viewing mode, several features are available to make watching TV a true pleasure. This chapter
describes these features. Please also read chapter
7.0
to get familiar with the menu of your new
receiver.
6.1 Changing channels
Your new receiver is equipped with three ways to change channels.
1. Via direct access
2. Via the channel list
3. Via the
CH+/CH-
or
pq
buttons
4. Via using the
9
button
6.1.1 Direct access
To gain direct access to a certain channel, simply input its number with the
0~9
buttons on the
remote control. Channel numbers can be up to four digits long. Entering a number with less than four
digits is possible. After entering the channel number just wait a few seconds or press
OK
and your
receiver will switch to the selected channel.
Note:
Please note that when using the “HD Austria Senderliste” some channel
numbers may not be in the list or assigned. Personally stored or searched
channels will be stored from channel number 4000.
6.1.2 Channel list
Press
OK
in viewing mode to display the channel list. In the header section the corresponding name
of the selected channel list will be displayed, e.g.
HD Austria Senderliste
.Use
pq
inside the channel
list to highlight your channel of choice and press
OK
to switch to the highlighted channel.
The channel list is equipped with a filter function to make it easier to find your favourite channels.
While in the channel list, press
RED
. An alphabet banner will now be displayed. Use
pq
or
P+/P-
to
select the first letter or number of the channel you wish to filter for and press
OK
or
t
to change
to the filtered list. All channels beginning with the chosen letter will now be listed at the left side
(ascending order by channel number).
The following buttons are available in the channel list and in viewing mode:
TV/R
:
Toggles between TV and radio channels, in channel list changes the list mode.
LIST
:
Opens the satellite list selection in viewing and list mode in case there is more than 1
satellite installed.
FAV
:
Displays the favourite list selection in both modes. Details about creating favourite
lists can be found in chapter
7.2.1 TV Channel Manager
.
To return to the original respectively to the previous channel list /mode use
TV/R
or
LIST
.
6.1.3 Using the CH+/CH- buttons
CH+
or
p
will switch to a higher channel.