2-2
Technical Manual LDK 20(S) - Studio Camera
Installation
Packing/Unpacking
Inspect the shipping container for evidence of damage
immediately after receipt. If the shipping container or
cushioning material is damaged, it should be kept until
the contents of the shipment have been checked for
completeness and the units have been checked
mechanically and electrically.
The shipping container should be placed upright and
opened from the top. Remove the cushioning material
and lift out the contents.
The contents of the shipment should be checked
against the packing list. If the contents are incomplete,
if there is mechanical damage or defect, or if the units
do not perform correctly when unpacked, notify your
Thomson Multimedia Broadcast Solutions sales or
service centre within eight days. If the shipping
container shows signs of damage or stress, notify the
carrier as well.
If a unit is being returned to Thomson Multimedia
Broadcast Solutions for servicing, try to use the
containers and materials of the original packaging.
Attach a tag indicating the type of service required,
return address, model number, full serial number and
the return number which will be supplied by your
Thomson Multimedia Broadcast Solutions service
centre.
If the original packing can no longer be used, the
following general instructions should be used for
repacking with commercially available materials:
a. Wrap unit in heavy paper or plastic.
b. Use strong shipping container.
c. Use a layer of shock-absorbing material around all
sides of the unit to provide firm cushioning and
prevent movement inside container.
d. Seal shipping container securely.
e. Mark shipping container FRAGILE to ensure careful
handling.
Local / Remote Power Supply
The LDK 20 camera is delivered ready to operate in the
remote mode. If the camera has to be used in the local
(stand-alone) mode, carry out the following instructions
to allow the power to be supplied via the mains power
supply input connector on the right side connector
panel:
a. Disconnect the mains power supply or the triax
cable, whichever is connected.
b. Loosen two screws and remove the rear connector
panel of the camera.
c. Locate the remote/local switch - a large black
plastic box.
d. Set the switch to the local position. The camera is
delivered with the switch in the remote position.
f. Return the rear connector panel to its position.
R
E
M
O
T
E
230V
115V
Local/remote
Switch