THOMSON SpeedTouch 350, Setup And User Manual, Page: 54 / 58

4 Support
E-DOC-CTC-20031204-0011 v2.0
52
4.3 Resetting the SpeedTouch™
Reset to default
configuration
Proceed as follows:
1
Make sure the SpeedTouch™ is powered on (Power LED is solid green).
2
Use a pencil to press the recessed reset button ( D ) on the SpeedTouch™ rear
panel for at least six seconds until all the LEDs on the front panel turn off
3
As soon as all the LEDs on the front panel go off, release the reset button. This
indicates that the SpeedTouch™ is restarting in its default configuration.
Note
Make sure to release the reset button as soon as all the LEDs have
gone off to prevent that the SpeedTouch™ enters BootP mode.
The SpeedTouch™ will come online again with default settings.
D