Assembling the Units
Operator’s Manual LDK 200 Triax
2-3
Lens
To attach a lens to the camera head proceed as
follows:
a. Ensure that the lens locking ring
1
is in the
unlocked position - turned counterclockwise.
b. Remove the dust protection cap
2
.
c. Slot the lens into the lens mount
3
.
d. Turn the lens locking ring
1
clockwise to lock the
lens in place.
e. Connect the lens cable to the lens connector
4
at
the right side of the camera.
f. Place the lens cable into the bottom clip at the front
of the camera and clip
5
located at the side. (Pull
and twist clip
5
to open it.)
g. Select the lens type in the Lens menu. Set the
Lens Type item to Std for a standard lens or to WA
if an wide angle lens is mounted.
h. Select the lens manufacturer in the Lens menu.
Select Ang for Angenieux, Can for Canon, Fuj1 or
Fuj2 for Fujinon or select Other for other lens
manufacturers.
CAUTION
Do not attach a lens weighting more than
5 kg to the camera without a support.
When a new lens is fitted to the camera it may be
necessary to carry out some adjustments to optimize
its use, for example, back focus or shading. For more
information about these adjustments refer to Section
5 and to the lens manufacturer’s documentation.
Note: Always mount the dust protection cap when the
lens is not connected to the camera.
bts1009
1
2
3
4
5
