5
Getting started
EN
Using the remote control for other equipment
The remote control supplied with your television may vary depending on the model you have chosen. Some remote
controls can be used for other equipment, such as video recorders or DVD players.This page provides information
concerning the remote control’s use with some of these other types of equipment.
VCR
DVD
VCR
Press the
VCR
button
DVD
Press the
DVD
button
On/Standby
On/Standby
MENU
To display the main menu
To display the main menu
Vertical scrolling in menus
Vertical scrolling in menus
Horizontal scrolling in menus
Horizontal scrolling in menus
OK
To confirm an action
To confirm an action
EXIT
To close a menu
To close a menu
0-9
To directly access channels or enter
To enter numeric values or select options
numeric values
in menus
PR+/PR-
To change channels
AV
To select av input
REV
Rewind
Rewind
PLAY
Play
Play
FWD
Fast forward
Fast forward
STOP
Stop
Stop
PAUSE
Pause picture
Pause picture
REC
Record
Programming the remote control
Automatic code search
This method can be used to automatically find the most appropriate code for your appliance.
1.
Switch on the appliance you wish to use the remote control with.
2.
Press the relevant button for this appliance on the remote control, and while holding this button down, press the
standby button until the remote control light comes on. Release the two buttons.
3.
Point the remote control at the appliance and press
PLAY
.Wait until the light stops flashing. If the appliance has not gone
into standby mode after five seconds, press the
PLAY
button again to continue the search for the next set of codes.
Repeat this operation until the appliance goes into standby mode.There are 20 sets of codes.
4.
When the appliance goes into standby mode, press the standby
button on the front to switch it on again.Then press
the
REV
button to put it back in standby mode, and if necessary, keep pressing until the appliance goes into standby.
5.
Press the
STOP
button and hold it down until the remote control light goes off.
Note: you can cancel the programming operation at any time by pressing the
EXIT
button.
Manual programming
This method involves carrying out a manual search for the codes to be used for controlling your other appliances.
1.
Switch on the appliance you wish to use the remote control with.
2.
Press the relevant button for this appliance on the remote control, and while holding this button down, enter one of the
four-digit codes relevant to your make of appliance (there is a list of codes at the end of this manual). If the remote
control light flashes you have entered the wrong code or it is not possible to program the remote control.
3.
Point the remote control at the appliance and press the relevant button (
VCR
or
DVD
). Press the
standby button. If
the appliance does not go into standby mode, try another code.
Depending on the year of manufacture and the type of appliance, some functions may not be available.
Certain codes may cover more functions than others.Test the functions you can control and, if appropriate, try other codes.
Note here the code(s) which work best.
When you
change the remote control’s batteries
, remember to
reprogram
it.
VCR
DVD/LD
ITC008-EN-2 24/03/04 13:06 Page 5
