![THOMSON grass valley XtenDD Manual Download Page 70](http://html.mh-extra.com/html/thomson/grass-valley-xtendd/grass-valley-xtendd_manual_1110062070.webp)
4. Connection and Startup
4 - 9
Planning and Installation - Rev. 0 / 04.2002
4.3.2
RPS35-2 / RPS35-3 AND RPS35-4/32 CONTROL PANELS
Keyboard
COM 1
SCSI
Panel link output
PS/2 Mouse
VGA
LAN
J1
J3
J5
J6
J7
J8
J9
COM 2
J2
GPI/GPO
J19 a
J14
J13
AUX PANEL
WIPE PANEL
AC Power in 2
DC Power out
PE
Modem
J22 b Wipe selection
Aux selection
J23 b
J23 a
J22 a
Port 5
Port 4
J19 b
Port 6
Port 3
LAN
Port 1
Port 2
J20 a
J20 b
J21 a
J21 b
RS 485 / RS 422
RS 232
Interface
Ω
Connection Panel 2, RC 2374 Controller
Connection Panel 3, RC 2371 PC
BNC T-type connector
50
Terminator
Part of delivery:
BNC T-type connector
50
Terminator
Part of delivery:
Auxiliary DC out
12V
50/60Hz
50/60Hz
R
AC Power in 1
J11
2A
+
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
Caution: Do not remove any cover. Risk of electrical shock. High current level.
No user serviceable parts inside. Refer servicing to qualified service personnel.
Available energy >240VA.
Attention: Ne pas enlever cette plaque. Tension dangereuse. Prière de s’adressera
au personnal qualifié. Alimentation >240VA.
Achtung: Abdeckung nicht entfernen. Gefährliche Spannungen. Hohe Stromstärken.
Öffnen nur durch ausgebildetes Servicepersonal. Verfügbare Energie >240VA.
Caution: This unit has two power cords. To prevent electric shock disconnect both power
cords before servicing.
Attention: Cet appareil comporte deux cordons d’alimentation. Rafin de prevenir les choc
électriques, débrancher les deux cordons d’alimentation avant de faire le depannage.
Vorsicht: Dieses Gerät hat zwei Netzkabel. Vor Servicearbeiten beide Netzkabel entfernen.
Gefahr des elektrischen Schlags.
Caution: See installation manual before
connecting to the supply.
Attention: Lisez le manuel avant
l’installation d’alimentation.
Vorsicht: Vor Anschluß an das Netz
Installationsanleitung beachten.
J12
7
J15
100−240V; 2,5Amax;
100−240V; 2,5Amax;
Control panel
J17
J18
12
13
14
7
8
9
10
11
1
2
3
6
4
5
IPC-LAN
J10
Using the PS/2 mouse.
The following PS/2 mice have been tested and released for being
used with the RPD35-2/-3 panels:
S
PS/2 mouse no. 18.01.1060 from Roline (included in the delivery)
S
PS/2 mouse no. 18.01.1026 from Microsoft
Note:
The RPD35-2/-3 panels are provided with a 3.5” floppy disk
drive. Suitable 3.5” disk types and adapters, see chapter 2.18
“Floppy Disk Drives” in the operating instructions.
Note:
In compliance with the EMC regulations, the housing of the
RPS35-4/32 panel must be connected with functional earth!
RPS35−4: 3.5A max
RPS35−4: 3.5A max
17
15
16
21
20
19
22
23
18
24
Connection Panel 1,
RC 2375 Power Supply for Control Panels RPS35-2 and RPS35-3
RC 2810 Power Supply for Control Panel RPS35-4/32
Summary of Contents for grass valley XtenDD
