52
KAM-XM-SERIES Instruction Manual
Configuration and Adjustments
Temporal Recursive Web Page
The Temporal Recursive web page is active only on the KAM-XM-UNC
module.
This is a motion adaptive temporal recursive filter that works well in
removing random and Gaussian noise. Refer to
for a discussion on using this filter.
Enable the Temporal Recursive control by selecting
On
in the
Enable
pull-
down.This filter can operate in either
Auto
or
Manual
mode.
Auto Mode
Use the following controls for removing noise:
•
Red Overlay
– when enabled (
On
), a red overlay is superimposed onto
areas in the input image where the temporal recursive filter identifies
motion.
•
Auto
– enabling this mode (
) engages a feedback controller that
dynamically sets the
Distance
,
No Motion
and
Motion
control setting avail-
able in
Manual
mode based on noise and motion measurement extracted
from the scene.
•
Bias
– is active only in
Auto
mode. This control adjusts the noise set point
in the temporal recursive controller. The higher the bias the more
aggressive the controller is towards noise in the scene. The lower the
bias setting the more sensitive the controller is towards motion.
Figure 28. KAM-XM Temporal Recursive – Auto Mode
Use
this
link
