- EN 5 -
Setting the Clock
After the unit is plugged into a mains supply or following a mains power failure, the display will show
“0:00” on the LED display. The unit should be in standby mode to set the current clock.
1.
Press the
TIME/ALARM
button; the digits for the display will blink.
2.
Press the
/
button repeatedly until the correct hour is set. Press the
TIME/ALARM
button
to confirm the hour setting.
3.
The minute digits on the display will blink.
4.
Press the
/
button repeatedly until the correct minute is set. Press the
TIME/ALARM
to
confirm the minute setting.
Setting the Alarm
This unit can be used as an alarm clock, CD /USB/SD/FM is activated to play at a preset time.
1. Press
to switch the unit to standby mode.
2.
Make sure that you have set the clock correctly.
3.
Press and hold the
TIME/ALARM
button in shutdown state; the display will flash ON to select
setting the alarm and the display will blink.
4.
Press the
ALARM
button to confirm; the time display will blink.
5.
Press the
/
button repeatedly to set the hour. Press the
TIME/ALARM
button to confirm.
6. Press
/
to set the minute.
7. Press
ALARM
to confirm, and then press
/
to select CD /USB/SD/FM status. Press
TIME/
ALARM
to confirm.
8.
The volume turns up from 0 to 20 gradually.
9.
Press the
TIME/ALARM
button in shutdown state; the display will flash ON to select setting the
alarm, and the display will blink.
10.
Press the
/
button to select OFF to cancel the alarm.
Sleep Mode
Press and hold the
SLEEP
button; the display will blink. Press the button repeatedly until the display
shows the minute you want to set. You can set 10 to 90 minutes.
It blinks three times to confirm, and then returns to the previous interface. If you want to cancel the
sleep mode, press OFF. After blinking three times, sleep mode will cancel.
Play
Play a disc
1. Press
SOURCE
repeatedly to select DISC source.
2.
Press the to open the CD tray, put on a disc with the printed side facing upward and press
again to close the CD tray.
3. Play starts automatically, if not, press .
4. Press
VOL+/VOL –
to adjust the volume.
Pause / resume play
1. During play, press to pause/resume play.
2.
During play, long press the
/
button to fast forward/fast rewind.
Skip to a track
For CD:
1. Press
/
to select another track.
2.
Press the
VOL+/VOL –
to adjust the volume.
For MP3 disc and USB/SD
1. Press
/
to select a track or a file.
2.
Press the
VOL+/VOL –
to adjust the volume.
