THOMSON DFT-6108, User Manual, Page: 7 / 27

DFT-6108 Battery Analyzer
Instruction Manual
6
Setting interface Testing interface End interface
In the single-cell battery measurement interface, there are three options: "Voltage Type", "Battery Type", and
"Battery Number". It can be set according to the site situation. Standard Internal Resistance is the meter default.
After setting the parameters, click Start Measurement.
Measurement result parameters:
R Battery Ohm Resistor (uΩ)
R2 Battery Polarization Resistor (uΩ)
C2 Electrode Double Layer Capacitor (F)
U Battery Voltage (V)
Click the [Back] button at this time to return to the previous menu. Click the [Re-measure] button, the battery will
be measured again, if the test clip and the battery are not in good contact, the measurement result is very different,
and at this time you can re-measure again. Click the Waveform button to view the battery measurement waveform
graph. Click the [Save] button to save the interface.
Note:
A) The tester will automatically detect if the connection is correct, and if the connection is wrong or not
connected, the tester will prompt "Polarity reversed, check the connection"
B) Battery capacity is based on the average value of the battery internal resistance provided by each
manufacturer in the standard state and the value of the calculation, due to the different battery resistance of
each manufacturer, the battery capacity may be biased, the actual capacity should be corrected according to
the standard battery resistance of each manufacturer.