DFT-6102 Battery
Conductance
Tester Instruction Manual
15
Chapter 5 Routine maintenance
5.1.
Cleaning maintenance
(1) Cleaning and maintenance of the host
Wash the main unit with a soft damp cloth and a mild detergent. Please do not use abrasive type. Dissolving
cleaners or alcohol, etc., so as not to scratch the host panel or damage the text on the host.
(2) Cleaning and maintenance of voltage test cable clamps
Use a soft damp cloth with a mild detergent to clean the voltage clamps. After cleaning, wash it with clean water
and dry it. Do not scratch the metal part of the probe to avoid poor contact and errors in the test results
5.2.
Storage
After used, the host should be placed in the chassis in time. All clamps and cables should be organized and placed
in the appropriate position in the chassis. In order to keep the battery in optimal condition, it is recommended to
charge the battery regularly (once a month)
5.3.
Tester’s Battery maintenance
(1) Battery charging
At the time of delivery, the battery may not be charged and should be charged before use. Power on to check the
charging status, if the battery voltage is too low to turn on the machine, recharge a few minutes and then look.
After full charge, the battery can generally be used for 5 to 6 hours.
When charging, connect the charger and the console to charge without turning on the system. (It is recommended
to start charging)
If charged for a long time, such as during the entire weekend, it will not cause damage to the tester
Note: person must supervised standby if long time charging
（
2
）
Extend battery operating time
Fully charge before use, and the tester power off when not measuring for a long time during use.
