THOMSON 520013, User Manual, Page: 7 / 26

7
EN
WIFI CONTROL MODULE FOR DOUBLE SWITCHES
C - INSTALLATION
1 - OPERATION
Ideally placed behind a light switch or in the ceiling,
this micro module will allow you to remotely control
up to two lights with a maximum power of 1000W. You
can thus control your lights locally using the original
switches or remotely with your smartphone and the
Thomson At Home app.
Note: this module is compatible with all ADSL
2.4GHz routers.
IMPORTANT: The network compatibility of this
device is 2.4 GHz WiFi - WPA/WPA2. Not compatible
with 5 GHz WiFi or with WEP encryption.
Please check the WiFi settings of your router
or contact your Internet service provider if you
experience connection difficulties.
2 - CHOICE OF LOCATION AND CONNECTION
IMPORTANT:
Before permanently attaching your
accessory, it is recommended that you check the
range. To do so, place your micro module as close
as possible to its final location before you attach it
and test your accessory.
The micro module can be installed either behind an
existing switch or behind a ceiling fixture.
2.1 INSTALLATION BEHIND A SWITCH
NL O1 O2 SCS 1 S2
After the electrical supply has been disconnected,
disconnect the existing wall switch. Connect the
module according to the assembly plan.
N
P
1
2
Switch
2-channel phase
230VAC 50Hz power supply
Single channel phase
2
1
NOTE:
Do not connect SC, S1 and S2 to the mains,
they must be connected to the switch without an
electric current or voltage. When pressure is first put
on the switch, the micro module recognises if the
switch is a push button or a bistable switch. Both
are compatible.
2.2 INSTALLATION BEHIND A CEILING FIXTURE
N L O
1
O
2
SC S
1
S
2
After the electrical supply has been disconnected,
open the ceiling recess-mount housing. Connect the
module according to the instructions
N
P
2
1
230VAC 50Hz power supply
2-channel phase
Single channel phase