THOMSON 513628, Instructions Manual

Page: 8 / 12

WIRELESS WEATHER STATION
EN
8
www.thomsonsecurity.eu
C - CONFIGURATION
1 - QUICK START-UP
These steps must be followed in order.
Insert 2 AA LR06 batteries (not supplied) into the
station 15 . Then insert the 2 AAA LR03 batteries (not
supplied) into the outdoor sensor, ensuring that the
polarity is respected
16
.
PAIRING THE SENSOR TO THE STATION
Pairing is automatic once the batteries are inserted.
To force pairing, if required:
- On the station, press and hold the button for 5
seconds
DOWN , the indicator starts blinking
- On the outdoor sensor, remove then reinsert the
batteries, positioning yourself near the weather
station
TIME AND DATE SETTING
- Hold the SET button until the " °C " starts flashing.
- Set the measurement unit choice using the + and
- buttons ( °C = Celsius or °F = Fahrenheit).
Confirm using the SET key.
- 24h or 12h flashes on the screen. Set the time
display format using the + and - buttons.
Confirm using the
SET
key.
- Both digits: 00 flashes on the screen: set the time
zone using the UP and DOWN buttons.
Confirm using the SET key.
- Then set the hour using the + and - buttons.
Confirm using the
SET
key.
- Set the minutes using the + and - buttons.
Then confirm using the SET key.
ALARM SETTING
- Press the SET button once: the letters AL appear
on the hour side.
- Press and hold the SET button for 3 seconds : The
hour of the alarm flashes on the screen.
Set the hour of the alarm using the + and - buttons
- Press the SET button to confirm. The minutes flash
on the screen.
- Set the minutes of the alarm using the + and -
buttons
- Press the
SET button to confirm. Zz 05 flashes on
the screen.
- Set the alarm snooze duration using the + and -
buttons
- Finish the configuration by pressing quickly on the
SET
button
- When the alarm goes off, pressing the Snooze/
Light button cuts off the alarm and postpones it
to the pre-set time ( Zz ).
To set the alarm, press once on the + button: a bell
icon (3) appears between the hour and the
minutes.
To turn off the alarm, press the + button once: the
bell (3) disappears.
The tone lasts for a maximum of 2 minutes.
AUTOMATIC TIME SETTING
To launch the automatic time setting for the station,
press and hold the + button until the LED flashes
( 4 ). The station switches to radio reception (for 7
minutes) and attempts to pick up the DCF77 time
signal to automatically update the time and date.
Note: the time zone must be set correctly for a
correct display. If reception is insufficient, please set
the station near a window.
Ensure that you leave a gap of 2.5 m between the
station and any source of interference (television,
router, microwaves, etc.)
The signal search can be cut off at any point by
pressing the + button, if the signal is not available.
MIN - MAX VALUE DISPLAY
- Quickly pressing on MEM displays the maximum
values measured; pressing
MEM
again displays
the minimum values.
A third press on
MEM
returns to the current value
display. Pressing and holding for 3 seconds on
MEM erases the MIN/MAX values saved.