THOMSON 42WB03SW - annexe 1, Manual

Page: 11 / 24

11
EN
USING THE MONITOR
Powering ON / OFF
1. Make sure the monitor is connected ot
the wall outlet and that the power switch
located at the rear of the monitor is
switched to the ON position. The Status
LED must be yellow.
2. Press the POWER button on the front
panel.
3. The monitor will now turn on after a brief
pause. The Status LED will now turn
green to indicate power on status.
4. To turn power off, press the POWER
button on the front panel.
Status LED
! ! ! ! !
Off - No AC Power
detected
If the main power switch
(rear of panel) is turned off,
this LED will not illuminate.
! ! ! ! !
Yellow - Standby (Power
OFF) with AC power
detected
The LED will illuminate in
yellow color if the monitor is
shut-off but the power cord
is plugged into the back of
the unit.
! ! ! ! !
Green - Power ON
POWER (Toggle)
Selecting Signal Source
1. Press the INPUT button on the front panel to select one of the
available input signal soruces.
Input Select
(Toggle)
Adjusting Sound Volume
1. Use the volume ajustment buttons on the front panel to
increase/decrease the volume.
2 Sound mute: Press the mute button on the remote control to
temporarily mute the sound. Press again to restore it.
/-
This button is only active in RGB mode (when you connect a
PC, directly or through the tuner unit).
These buttons are only active in RGB mode (when you connect
a PC, directly or through the tuner unit).
42WB03SW-EN-5-062303.p65 2003/6/23, PM 04:52 11