IS---0235
October 2000
Page 2 of 2
STEP 2
Attach hotstick to eye of insulated parking bushing carriage
assembly. Slide carriage assembly into parking stand.
Push bail out of way so it will not interfere with placement of
elbow connector.
Parking
Stand
Hotstick
STEP 3
Follow the applicable instructions to make a voltage test
before removing the elbow connector from the apparatus
bushing. Remove elbow connector from apparatus
bushing and place on insulated parking bushing. DO NOT
REMOVE IF VOLTAGE TEST INDICATES CONNECTOR IS
ENERGIZED.
To Ground
Elbow Connector
STEP 4
BAIL MUST BE USED TO SECURE ELBOW.
Position the bail eyebolt directly over the bail locater on the
elbow. Tighten down on bail locater by turning eyebolt with
the hotstick in a clockwise direction. If entire assembly
(insulated parking bushing and elbow) is to be removed
from parking stand, attach hotstick to eye of carriage
assembly, remove from parking stand and place where
desired. To return elbow connector to apparatus bushing,
simply reverse the operational sequence.
Bail Eyebolt
Bail Locator
Esna Park Drive, Hackettstown, New Jersey 07840 USA
(908)852--1122 FAX: (908)813--2147
A Unit of Thomas & Betts Corporation
