© 2009 Thomas & Betts. All Rights Reserved.
WARRANTY:
Thomas & Betts sells this product with the
understanding that the user will perform all necessary tests to
determine the suitability of this product for the user’s intended
application. Thomas & Betts warrants that this product will be
free from defects in materials and workmanship for a period
of two (2) years following the date of purchase. Upon prompt
notification of any warranted defect, Thomas & Betts will, at
its option, repair or replace the defective product or refund
the purchase price. Proof of purchase is required. Misuse or
unauthorized modification of the product voids all warranties.
Limitations and Exclusions:
THE ABOVE WARRANTY IS THE
SOLE WARRANTY CONCERNING THIS PRODUCT, AND IS IN
LIEU OF ALL OTHER WARRANTIES EXPRESS OR IMPLIED,
INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE, WHICH ARE SPECIFICALLY DISCLAIMED. LIABILITY
FOR BREACH OF THE ABOVE WARRANTY IS LIMITED TO COST
OF REPAIR OR REPLACEMENT OF THE PRODUCT, AND UNDER
NO CIRCUMSTANCES WILL THOMAS & BETTS BE LIABLE FOR
ANY INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL
DAMAGES.
Thomas & Betts Corporation • Memphis, Tennessee • www.tnb.com
TA04486 A Page 2 of 2
ACTIVATION INSTRUCTIONS
(AFTER CONCRETE POUR)
8. Remove concrete from access frame. Break off
plastic retainers (2) and use knockout to remove
plate. See figure 5.
9. Install devices in accordance with N.E.C and
prevailing local electrical codes.
10. Place non-metallic tunnel in box on top of separate
services by removing selected tabs for feed through.
Use the snap-in partition (step 4) to isolate low
power service or to close an open tab. See figure 6.
11. Install the device panels by locating the bottom edge
in the locking tabs on the non-metallic tunnel and
securing the top with the (2) #6-32 screws furnished
with each device plate. See figure 7.
12. Complete the activation with the 665-CST cover
using the (4) #8-32 screws furnished with each cover.
REMOVE RETAINERS
PRY HERE
Figure 5
PARTITION MAY BE
USED TO SEPARATE
SERVICES
REMOVABLE TABS
FOR WIRE FEED
PARTITION USED TO
CLOSE AN OPEN TAB
Figure 6
Figure 7
#6-32 SCREW
