thomann igniton Strip Blinder X 10x75W, User Manual

Page: 40 / 44

Symptom Remedy
The unit does not work, no light Check the mains connection and the main fuse.
No response to the DMX con‐
troller
1. If the [DMX] LED is not lit in ‘DMX’ mode, then no valid
DMX signal is received. Check whether the DMX con‐
troller is switched on. Check the DMX connectors and
cables for proper connection.
2. If the [DMX] LED is lit in ‘DMX’ mode but there is still
no response, check the address settings and the DMX
polarity.
3. Try using another DMX controller.
4. Check whether the DMX cables run near or parallel to
high-voltage cables that may cause damage or interfer‐
ence to a DMX interface circuit.
If the procedures recommended above do not succeed, please contact our Service Center. You
can find the contact information at www.thomann.de .
Troubleshooting
blinder
40