5
OPERATION
Pre-start-up inspection
The following
p
re-start-up inspection must be performed before the start of each work session or after every four hours of
us
e.
If any fault is discovered, the
machine should be deemed not operational
until the fault is rectified.
1.
T
horoughly inspect the
machine
for signs of damage.
Remove any dirt, debris, or material that may have accumulated
from prior use. Clear any dust accumulation from the air filter, carburetor, and engine cooling unit.
2.
Check components
and all hardware is
present and secure.
3.
Check engine oil level
4.
Check fuel level
5.
Check for fuel line and oil leaks
Petrol Engine
Start and
S
top Procedure
1.
Open the fuel
valve lever
to the "ON" position
2.
If starting the engine from cold, set the choke
to the "CLOSED" position
(I
f restarting a warm
engine, the choke
is
usually not required.
)
3.
Turn the engine ON/OFF switch to the “ON" position.
4.
Set the throttle to the idle position by moving the throttle lever fully to the right.
5.
Taking a firm hold of the recoil starter grip and slowly pull the recoil starter until
resistance is felt then pull out sharply.
a.
Do not pull the recoil rope to full extension
b.
Allow the recoil rope to retract without releasing your hold
6.
As the engine warms up
, gradually set the choke lever to the "OPEN" position.
7.
To begin compacting, set the throttle to the "FAST" position.
8.
To stop the engine, set the throttle to idle
and allow engine to run for 2 to 3 minutes
9.
T
ur
n
the engine ON /OFF switch to the “
OFF
” position.
10.
Close the fuel valve lever to the "OFF" position
.
EXTENDED STORAGE
For machine storage over 30 days, the following is recommended:
•
Thoroughly clean the machine
•
Check and repair any leaks or loose hardware
•
Drain the fuel tank completely
•
Check engine oil and top off if necessary
•
Clean the fuel filter
•
Clean the air filter
•
Store machine in a clean and dry indoor storage
TRANSPORTATION
1.
Always shut off engine when transporting machine.
2.
Make sure lifting device has enough capacity to hold machine (see identification plate on machine for weight).
3.
Use lifting point when lifting machine.
4.
Wheel Kit is
optional
and can be
used for short distance transportation.
