SCPI Command Set
:SWEep:LIST:STOP
This command stops the sweeping and stores the entry index where it is stopped. The
WSA retains the settings of the last performed sweep entry when :STOP command is
executed.
Syntax
:SWEep:LIST:STOP
Parameter/Response
None
*RST State
N/A (Sweep stopped)
Examples
:SWEEP:LIST:STOP
:SWE:LIST:STOP
Note:
This command should be issued to clear the WSA5000's data buffer of any data
that has not been sent from the WSA5000 prior to setting up the next capturing process.
:SWEep:ENTRy:COPY
This commands will copy and populate all the capture engine configurations under
:SWEep:ENTRy with values from the sweep entry of the specified index. No new entry is
created until
command is issued and any changes will not affect
the existing entry.
Syntax
:SWEep:ENTRy:COPY <integer>
Parameter
<Sweep entry integer index>
Input Data Type
Unsigned integer
Allowable Values
If :COUNt? returns non-zero, 1 to :COUNt? value
If :COUNt? returns zero, an execution error is returned
Query Response
None
*RST State
N/A
Examples
:SWEEP:ENTR:COPY
:SWE:ENTRY:COPY
:SWEep:ENTRy:COUNt?
This query command returns the number of entries available in a list.
Syntax
:SWEep:ENTRy:COUNt?
Parameter
None
Query Response
<integer>
Output Data Type
Integer
*RST State
N/A
Examples
:SWEEP:ENTR:COUNT?
ThinkRF WSA5000 Wireless Signal Analyzer Programmer's Guide
77