Thies CLIMA DLx-MET, Instructions For Use Manual

Page: 16 / 56

2.1.9 Setting Digital Input
The digital input „Event / Length of time” (Sensor 10) can be configured for two possibilities with the
Jumper P2:
Jumperposition P2 Logic * Inverse Level Miscellaneous
2 3.3V(5V TTL) No Pull-up Resistor 100k Ω to 3.3V
3 1V Yes ** Resistor > 1k Ω
Table 2: Jumper for digital input
* The corresponding switching levels are listed in the technical data (see chap.
6
)
** Note that with jumper in position 3 the logic level is reversed by the electronic.
The jumper P2 is situated 2 cm above clamp 13 (see
Figure 12
). To change or check the position it
is necessary to remove the front plate (see
Figure 5
, ref. to chap.
2.1.8
).
Figure 12: Jumper for Digital Input
16 - 56 021579/06/09