THIEMAN Tailgates M16, Owner'S Manual & Parts List

Page: 3 / 24

3.
+ ThIS IS NOT A PERSONNEL LIFT. Because of the pinch point between the platform and
the truck, fall hazards, unstable loads, etc., riding the lift may cause severe personal injury
or death. ALWAYS stay clear of the liftgate when in operation. Do NOT ride the liftgate.
+ This liftgate is intended for the use of loading and unloading cargo only, it is not to be used
for anything other than this.
+ DO NOT OVERLOAD ThE LIFTGATE. Each liftgate has a specific maximum capacity for
lifting and lowering. The standard maximum rated capacities of the M series liftgates differs
with each model as follows:
M16 - 1600 lbs. Maximum Load
M20 - 2000 lbs. Maximum Load
NOTE: Special options can lower the maximum rated capacities below those shown above. Be
certain you know what the maximum rated capacity is for your particular liftgate.
+ NEVER off-center the load on the platform, from side to side or away from truck as this may
overload the liftgate. The center of weight of the load should NEVER be placed beyond the
center of the platform load surface, away from truck. Loads should be placed close to
platform edge nearest truck. See figure 1.
+ NEVER allow any part of the load to extend beyond the edges of the platform's flat load
surface.
+ NEVER allow any part of the load to extend over or on, the tapered ramp portion of the
platform unless the platform is lowered completely to the ground and the ramp is supported
by the ground.
+ NEVER lift or lower unstable loads.
+ NEVER operate liftgate if platform load surface is slippery.
+ Make certain that the area below the platform is clear before and at all times during
operation of the liftgate.
+ Load and unload the platform from the rear and not from the side of the platform.
+ Never operate lift trucks on or over any part of the platform.
+ Follow the maintenance guide as outlined in this manual.
+ NEVER move vehicle unless platform is properly stowed and power is off. Locking cams
must be properly pinned before transit.
+ Anytime the vehicle is washed, this liftgate MUST be inspected to MAkE SURE all parts
are properly lubricated and have the appropriate protectants. Failure to replace lubricants
and protectants after washing the vehicle, may lead to improper operation of the liftgate,
accelerated corrosion, and possible component failure.
PARTS ORDERING PROCEDURE
When ordering parts, please include all the information asked for below. If this information is
not available, a complete written description or sketch of the required part will help Thieman
identify and deliver the needed part to you.
ThE FOLLOWING INFORMATION MUST BE INCLUDED:
1. Serial Number – Thieman liftgate serial numbers can be found on the tag located on the
front side of the trunnion tube.
2. Model Number and Capacity.
3. Platform size and Material – Steel or Aluminum.
4. Part number.
5. Description.
6. Quantity required.