OPERATIN G IN STRUCTIO NS
SETTIN G THE THERMOSTAT
1
.
Rotate thermostat knob clockwise to high position
.
ADJUSTIN G AIR FLOW DIR ECTIO N
1.
Turning the Unit
-
IF the unit has been installed with
a single lag bolt
,
as shown in the Figure 4a
,
simply
2.
After room reaches desired comfort level
,
rotate
thermostat knob counter
-
clockwise until the thermostat
clicks off
.
turn the entire unit as needed to adjust air flow
.
2.
Tilting the unit
-
Loosen the bracket screws
(
See
Figure 5
)
3.
To protect the heating element
,
when starting the heater
slowly turn the temperature control clockwise
.
The unit
will start the heating element first then the fan
.
When closing the heater
,
slowly turn the
temperature control counterclockwise to the off position
.
The unit will shut off the heating element first and then
the fan
.
NOTE
:
Heater will cycle on and off to maintain room
temperature
.
THERMAL CUTOUT
The heater is equipped with a thermal cutout which
will automatically shut off the heater in the event of
overheating
.
The heater will turn on when it
'
s
NOTE
:
To tilt the heater it must be mounted in bottom
keyhole slots of mounting brackets to maintain
adequate clearance and prevent possible overheating
.
Rota te
3
.
Adjusting the louvers to the desired position
.
NOTE
:
The louvers are designed so they can not be
completely closed
.
Do not attempt to defeat this
feature
,
damage to the unit can result
.
temperature returns to normal
.
Should the unit overheat
!
WARNING
and cause the thermal cutout to cycle
,
the cause of
the overheating should be determined and corrective
action taken before further operation
.
To prevent possible electric shock
,
Disconnect power
to the heater at the main service box before
attenpting to adjust the heat output of this unit
.
WARNING
:
The heater must be properly installed before it is used
.
SETTING THE THERMOSTAT
1
:
Rotate thermostat knob clockwise to high position
,
POWER INDICATOR will turn yellow
.
2
:
After room reaches desired comfort level rotate thermostat knob counter clockwise to the off position
.
NOTE
:
Heater will cycle on and off to maintain room temperature
.
SELECTION
SWITCH
THERMOSTAT
CAUTION
INDICATOR
(
red
)
POWER
INDICATOR
(
yellow
)
