22
Programming Instructions
Programming the Duration, Frequency and Temperature Setting
Filter Cycles set the amount of time Pump 1 automatically operates in low speed to filter
the spa water. The user can customize the duration and frequency of the filter cycles. At the
beginning of the filter cycles, all pumps will activate to high speed for 1 minute to purge the
plumbing lines of water, thus improving the overall cleanliness of the spa water. During a filter
cycle, Jets Pump 1 can be set to low or high speed but cannot be turned off. If any other buttons,
than the Jets Pump 1 button, are pressed during a filter cycle, the filter cycle will be suspended
and will resume 40 minutes after the final button press.
A. Programming the Filter Cycle(s) duration:
• The duration can be programmed from 0 to 24 hours.
• It is not recommended to set the Filter Cycle Duration to “0” as
no filtration will occur.
• You can program up to 4 cycles per day, “F 1” to “F 4”.
1. Press and hold the Light (
) button for 5 seconds until the
display shows “dxx” (“xx” stands for the duration in hours,
default is 2 hours).
2. Press and hold the Warm/Cool (
) button to adjust the
duration of the cycle in one hour increments. If the duration
time is going in the wrong direction, release the Warm/Cool
button then press and hold to move in the opposite direction.
3. Press the Light (
) button again to enter the filtration cycle
frequency program. The display will show “Fx” (“x” stands for
the number of cycles per day, default is twice a day).
4. Press and hold the Warm/Cool (
) button to adjust the cycle
frequency. If the frequency is going in the wrong direction,
release the Warm/Cool button then press and hold to move in
the opposite direction.
5. Press the Light (
) button again to enter the temperature
setting. The display will show “F” (default is Fahrenheit).
6. Press and hold the Warm/Cool (
) button to adjust the cycle
frequency. If the frequency is going in the wrong direction,
release the Warm/Cool button then press and hold to move in
the opposite direction.
7. Press the Light (
) button again to exit the programming and save your changes.
Note:
You must press and hold the Warm/Cool button to make changes. Pressing the button
once will only toggle the duration time between the current and the next setting.
Press and hold
for 5 seconds
(approx.)
Press and hold
to adjust hours
from d0 to d24
LED screen
displays
d 1
Press light button
to enter frequency
programming
Press and hold to
adjust hours from
F1 to F4
LED screen
displays
F 1
Press light button
to enter tempera-
ture setting
Press to toggle
between F or C
LED screen
displays
F
Programming Instructions
Summary of Contents for Atlantis Genesis 200
