Advice for user
- There is no point in setting maximum heating the room temperature will
not rise any quicker. If you leave for several hours, remember to reduce the
temperature.If you have several units in a room, let them operate simulta-
neously. This will give you a more uniform temperature without increasing
electricity consumption. This is also true for an unoccupied room it is
interesting to let the device on with a lower setting than turning it off
completely.
Maintenance
To maintain performances of your unit, you should clean the upper and
lower grilles of the unit about twice a year using a vacuum cleaner or a
brush. Have a professional check of the inside of the unit every five years.
Dirt may collect on the grille of the unit if the atmosphere is polluted. this
phenomenon is due to the poor quality of the ambient air. in this case, it is
recommended to check that the room is well ventilated (ventilation, air inlet,
etc.), and that the air is clean. The unit will not be replaced under the
guarantee because of this type of dirt. The unit casing should be cleaned
with a damp cloth, never use abrasive products.
2.3 Fixing the Eco temperature
- The Eco mode allows you to lower the comfort temperature of 3 to 4 ° C
during unoccupied periods of the room. It is recommended to use this mode
for periods of no more than 2 hours. Put the cursor H on ECO then adjust the
knob to the desired position, the heating indicator G lights if the ambient
temperature is lower than the desired temperature setting ECO. Wait until the
temperature stabilizes.
2.4 Frost-Free mode
- This is the position of the knob that keeps the temperature at approxi-
mately 7 °C in the room during a prolonged absence from home (genera lly
more than 24 hours). Put the H cursor on
2.5 Locking the controls
- It is possible to block or limit the use of the knob I and to block H cursor to
prevent any mani pulations.Detach the unit from the bracket. on the back of
the thermostat, remove the pieces 1 of their support.
- K position to block the knob.
- L positions to limit the operating range of the knob.
- M position to block the H cursor on the desired mode.
Summary of Contents for Evidence3
Page 1: ......
Page 6: ...5 2 标识解读 12 14 17 20 23 26 30 ...
Page 7: ...7 常见问题 ...
Page 8: ...Ev3落地支架安装示意图 各组件 步骤一 步骤二 步骤三 步骤四 步骤五 步骤六 安装后示意图 侧面 背面 ...
