18
For more information about our products and how to contact us, please visit thermopatch.com
Problem
Possible cause
Solution
The machine does not
switch on
The plug is not connected
The switch has not been
switched to 'on'
Main fuse is not working
Check the connection to the electric mains and if the
machine is plugged in
Press the main switch to 'on
The fuse is located in the fuse holder next to the power
cord connector.
The heating platenn
does not heat up
Faulty heating element
Problem with the main board
Temperature set too low
Check the connections and the condition of the wiring
Remove the heating element
Check the on-screen messages and refer to the section
error messages, page 9
The heating element
overheats
Problem with the probe of
electronic board
Check de messages on the LCD screen, page 9
Contact your supplier
The timer does not
count down
Disabled or faulty limit swithch on
the swing arm
Problem with the electronic board
Check the connections
Check the on-screen messages and refer to the section
error messages, page 9
The press head does
not lower
The pins are stuck, or too tight
The gas springs are stuck
Lubricat or loosen the pins slightly
Check the gas springs but do not try to open them! PARTS
UNDER PRESSURE, DANGER. Contact your supplier for
replacement
The press head stays
down after pressing
The gas springs are stuck
The timer is not counting down
Leaking gas spring gasket, pressure too low to open up
the machine. Check the gas springs but do not try to open
them! PARTS UNDER PRESSURE, DANGER.
Contact your supplier for replacement
See above
9.2 Troubleshooting
In this paragraph you will find the most common problems, causes and solutions.
WARNING!
All repair and maintenance operations should be done when the machine is turned off and unplugged
from the main electric power supply. Ensure that the machine has cooled down before starting repairs
or maintenance. The heating element can cause burns.
All repairs must be performed by qualified staff.
