Thermo Scientific
imPULSE S.U.M. with Touchscreen Console User’s Guide
|
87
Chapter 3
|
Touchscreen Console setup
Calibration
Set up a new conductivity calibration using either direct entry, 2-point,
or 3-point calibration. See Chapter 4 for more information on calibration
procedures.
1. If you would like to calibrate the conductivity, touch the
Calibration
field.
2. Follow the calibration instructions that are detailed in Chapter 4—
Calibration Procedures.
3. Touch
Done
to return to the Home screen.
3.4.13 Configuring the Liquid Pressure module
Use the following information and steps to configure the Liquid
Pressure module. To begin, Locate the Liquid Pressure module on the
Touchscreen Console Home screen, and touch
Configure
. The Liquid
Pressure Module Configuration screen will appear (Figure 3.66).
Note:
You can touch
Done
at the bottom of the Configuration screen
at any time to save your current settings and so you can resume later.
Figure 3.66. Liquid Pressure Module Configuration screen.
Required fields
Units
Enter the units that you would like the Touchscreen Console to use
when displaying the liquid pressure (either mbar or psi).
