ThermoFisher Scientific thermo scientific imPULSE S.U.M., User Manual

Page: 87 / 184

Thermo Scientific imPULSE S.U.M. with Touchscreen Console User’s Guide | 82
Chapter 3 | Touchscreen Console setup
2. Follow the calibration instructions that are detailed in
Chapter 4—Calibration Procedures.
3. Touch Done to return to the Home screen.
3.4.12 Configuring the Conductivity module
Use the following information and steps to configure the Conductivity
module. To begin, locate the Conductivity module on the Touchscreen
Console Home screen, and touch
Configure . The Conductivity Module
Configuration screen will appear (Figure 3.60).
Note: You can touch Done at the bottom of the Configuration screen
at any time to save your current settings and so you can resume later.
Figure 3.60. Conductivity Configuration screen.
Required fields
Units
Select the units you would like to use (either µS/cm or mS/cm).
1. Touch the Units field.
2. On the screen that appears, select the units you would like the
Touchscreen Console to use. You may select μS/cm or mS/cm
(Figure 3.61).
– Once a selection is made you will be returned to the Conductivity
Module Configuration screen.