Thermo Scientific
imPULSE S.U.M. with Touchscreen Console User’s Guide
|
114
Chapter 5
|
BPC loading instructions
Make BPC connections
1. Attach the tube sets (Figure 5.21), and tare the system (see section
6.1.4 Scales and weighing systems), if applicable.
2.
If your system has a PCD
, connect the BPC tube set for inflate/
vent air to the top 1.5 in. tri-clamp port on the left hand side of
the PCD box. Then connect the pressure sensor line to the lower
3/4 in. tri-clamp port on the left hand side of the PCD box.
Figure 5.19. Red handle pushed to
the left to clamp and lock the door.
Figure 5.20. Motor drive safety
guard replaced.
Figure 5.21. Connecting the tube
sets.
Figure 5.22. Location of the ports for
the air and pressure sensors on the
PCD.
1.5 in. tri-clamp
inflate/vent port
3/4 in tri-clamp
pressure sensor port
