ThermoFisher Scientific HERASAFE 2030i Series, Operating Instructions Manual

Page: 99 / 173

Herasafe 2030i / Maxisafe 2030i
50155215 | 89
Operation |
Chapter 6
Setting up AutoStop
Proceed as follows to set up the biological safety cabinet for AutoStop:
1. Tap the “Settings” icon on the Main Navigation Bar, followed by the “Programs”
button on the “Settings” screen.
Alternatively, you can also tap the “Programs” icon on the Main Navigation Bar.
2. Tap the “Edit AutoStop” button on the “Programs” screen.
Doing so will open up the “Edit AutoStop” screen shown in Figure 84 below. By
default, the
“Edit AutoStop” screen comes up with the “Fan off after UV” option and
all remaining checkboxes selected (top image in Figure 84).
Figure 84 “Programs” Screen: “Edit AutoStop” Screen
3. Tap to select one of three radio buttons to determine whether and when the fans
should be turned off after the “AutoStop” button has been pressed:

“Fan off after UV” selects the “UV on” option to have the biological safety cabinet
run UV disinfection after AutoStop.

“Fan immediately off”

“Leave fan on”
4. Tap to select or deselect any of the four checkboxes as required:
Thermo Fisher BSC
11:42 AM | 08/10/2018
Edit AutoStop
Close window
Fan off after UV Fan immediately off Leave fan on
Light off
Receptacle off
UV on
Save
UV runtime setting
Auto adjustment of UV disinfection cycle time
based on UV light bulbs operating hours
00 hr min 1
Thermo Fisher BSC
11:42 AM | 08/10/2018
Edit AutoStop
Close window
Fan off after UV Leave fan on
Light off
Receptacle off
UV on
Save
UV runtime setting
Auto adjustment of UV disinfection cycle time
based on UV light bulbs operating hours
00 hr min 1