ThermoFisher Scientific HERASAFE 2030i Series, Operating Instructions Manual

Page: 82 / 173

| Operation
72
|
50155215 Herasafe 2030i / Maxisafe 2030i
Chapter 6
The “UV Total hours” counter and “Last cycle” date will be reset to zero and a default
date, while the “Installed” date will be reset to the current date.
Figure 66 “Status Good” Screen #2: Operating Hours, UV and Filter (EU Version)
Figure 67 “Status Good” Screen #2: Filter, Power Consumption and Air Speed
3. Swipe the screen to the left or tap the right blue chevron in the navigation area at the
bottom center to display the second suite of status data, shown for the EU version in
Figure 66 and for the US version of the device in Figure 67 below.
4. When you are done viewing status data, tap the “X” icon in the upper right corner to
close the “Status Good” screen.
You will be returned to the Main Screen.
Reset the UV operating hours only when you have positively replaced the UV light bulb.
Resetting the operating hours without previously replacing the UV light bulb results in a
misleading operating hours count. When the lifetime of the UV bulb expires, UV
disinfection efficiency may be compromised, but no pertinent alarm message will be
given. This may result in latent biohazards that may go unnoticed.