Thermofilm Heatstrip THY2200P, Assembly Manual

Page: 7 / 12

7
Assembly Instructions
CAUTION :
To assemble this heater, you should obtain assistance from another person when handling the
larger, heavier pieces.
1
Install Base Brackets

Remove all the packing material and place on a non-abrasive
surface.

Position the Base as shown in the diagram.

Once the slotted holes are aligned, use 5 Pan Head screws
then tighten securely with the nuts provided

Install two Brackets to the Base using 4 Pan Head Screws
(M6x10mm), once brackets are in place tighten all the screws
securely.

Adjustable Skid Pads will be provided. Screw Skid Pads on
each corner as shown in the diagram.
Note: Base brackets can be concealed if angled inwards.

Attach the Lower Post to the Base by matching the
slotted holes on the Lower Post into the screws on
the Base. Next, attach 3 Pan Head Screws
M6x10mm, then tighten all the screws securely
Install Lower Post
Joining Base
2
3
Pan Head Screw M6x 10mm
QTY: 4
Pan Head Screw M6x 10mm
QTY: 3
Flange Nut M6
QTY: 5 Pan Head Screw M6x 10mm
QTY: 5