Thermo Scientific Surveyor UV Plus, Hardware Manual

Page: 39 / 76

2
Installation
Powering On the Detector for the First Time
Thermo Scientific Surveyor UV/Vis Plus Detector Hardware Manual 23
Most of the flow cells listed in Table 5 require the standard flow cell cover
(P/N 60053-40005). The 50 mm LightPipe flow cell (P/N 803237) requires the LightPipe
flow cell cover (P/N 60053-40004). The high pressure microbore flow cell requires the
microbore flow cell cover (P/N 60053-40006).
Powering On the Detector for the First Time
After you have installed the flow cell, the detector is ready to be powered on.
 To power on the detector for the first time
1. Ensure that the power switch at the front of the unit is in the Off position (released or out
position).
2. Attach the power cord to the power entry module on the back panel of the detector and
connect it to the power source.
3. Turn the power on by pushing the power button in to engage it.
Table 5. Optional flow cells for the UV/Vis detector
Flow cell type Path length (mm) Volume (μL) Part number
Kel-F™ bio cell 6 9.0 9550-0103S
3 mm semi-prep 3 4.5 9550-0101S
6 mm analytical 6 9.0 9550-0100S
High-pressure microbore 2 0.25 9550-0150-01S
Titanium bio cell 6 9.0 9550-0197S
3 mm microbore 3 1.2 9550-0053S
10 mm analytical
(standard on SRVYR-UV1) 10 15 9550-0234S
6 mm microbore 6 5.0 9550-0265S
Cuvette holder N/A N/A 9550-0263S
High pressure standard 6 9.0 9550-0267S
50 mm LightPipe 50 10 803237
IMPORTANT If you are using a previous version of the LightPipe flow cell that has
natural PEEK end caps, make sure the flow cell cover is in place before turning the
power on. When the instrument is powered on, it performs its Start-up diagnostics.
Ambient light can affect these diagnostics.
IMPORTANT Install the flow cell cover, which minimizes thermal fluctuations,
before you use the detector for data acquisition.