Thermo Scientific Sorvall ST Plus Series, Instructions For Use Manual

Page: 42 / 172

3-10
Graphical User Interface
3. 2. 4. Set Temperature
A refrigerated centrifuge allows for preselecting a temperature for the sample between -10 °C and +40 °C for
the centrifugation run. This feature is not available on ventilated models.
A
CAUTION
Due to air friction the temperature of the rotor may rise significantly while the centrifuge is
spinning. Displayed and set temperature can deviate from sample temperature. Sample temperature might
exceed critical temperature of your apllication.
Proceed as follows to set a temperature for the next centrifugation run:
1. Tap the temperature box on the “Home” screen, shown in Figure 3–21 below.
Figure 3–21: Temperature Box on Home Screen
The “Setpoints: Standard” screen or “Setpoints: Advanced” screen is displayed.
2. Tap in the Temp entry field, then use the keypad on the right to enter the temperature for the sample setpoint.
The admissible temperature range for the unit appears just below the “Temp” label to assist you in setting
the temperature setpoint correctly.
When you tap the
Temperature entry field, the previous setting will be replaced immediately as you start
entering digits on the keypad.
3. Tap the Save button to save the setpoint temperature for the next centrifugation run.