Thermo Scientific Smart2Pure Pro, Installation And Operation Manual, Page: 20 / 57

Smart2Pure Pro Ultrapure water system The Installation Area | 15
Figure 4. Smart2Pure Pro wall mount bars
2. Using (4x) included 5/16” lag bolts and washers, attach
the wall mount bracket on the wall where you want to
mount your Smart2Pure Pro system.
3. Lift the system (2 people recommended) and hang it on
the wall mounting bracket.
The spring loaded pin locks itself on the bottom lip of
mounting bracket to prevent tipping.
Figure 5. Smart2Pure Pro wall mount bracket
4. To remove the unit from the wall, pull on both cords at the
bottom of the mounting brackets (refer to
Figure 4
), and
lift (2 people recommended) the unit slightly and pull
away from wall bracket.
Attaching the Wall
Mounting Bracket for 30 L
or 60 L Pure Water Tank
Note:
• Wall mounting hardware for the 30 L or 60 L pure water
tanks (purchased separately).
• 30 L pure water tank wall mounting bracket,
Item No.: 06.5015
• 60 L pure water tank wall mounting bracket,
Item No.: 06.5016
• The wall on which the pure water tank is to be installed or
mounted must have an adequate load-carrying capacity
(check the capacity and stability of the wall. Refer to the
section
Technical Specifications
for weight and
dimensions for pure water tanks).
(4x) Included M8 x 25 mm
Side View of
Release
(2x) Device Mounted Bracket
Hook
Cord
(4x) included
Back Plate
Smart2Pure Pro
long screws
Down
(floor)
10 mm Spacer
Wall Mounted Bracket
(4x) Mounting Holes for attaching 16” spaced wooden studs
CAUTION:
Always lift and carry the system in
tandem (two people), never alone, to avoid any
risk of injury.
Lift the system at the two bottom corners.
Release Cord
Hook
(2x) Device Mounted Brackets
Spring loaded
pin lock
Mounted
Bracket
Wall