Getting started with your USB receiver
Follow these instructions to get your system up and running with a USB receiver and Smart-Vue
™
wireless module.
Before you begin
Install software & receiver
Add a sensor
1. These instructions provide a brief
introduction to the Smart-Vue
monitoring system. Please read the
Smart-Vue User Guide to benefit from
the full potential of your installation.
Access the manual from the software
(
Help
è
User Manual
) or on your
CD-ROM).
2. Do not plug in your USB receiver until
instructed by the installer software.
3. Software installation on the server
computer must be performed by a
system administrator.
4. We recommend connecting the
server to a uninterruptable power
supply for maximum reliability.
1. Insert the Smart-Vue CD into the
drive on your computer.
2. Select
Full installation
and follow
the instructions on your screen.
3. Select
USB receiver
in the
installation wizard.
4. When prompted, plug in your USB
receiver and continue.
5. Click on
Detect
to add the receiver to
your system.
6. Click on
Next
to create a user name
and password. The default super
administrator is “thermo”, with the
password “thermo”.
7. Finish the wizard.
8. Launch Smart-Vue Client and login.
1. With Smart-Vue Client running,
press the large button on the front
of the module you are installing, and
hold it 3 seconds or until
Searching
is displayed on the module screen.
2. If the receiver is within wireless
range, the module establishes the
wireless connection automatically
and is displayed in Smart-Vue Client.
If the module does not detect the
receiver automatically, you may
repeat these steps or install it
manually (
F11
>
F11
, as described in
the user manual).
Set up sensor reading and data transfer
1. Press
F11
.
2. Drag with your mouse to move the sensor
from the default “SDP” group (if that’s where
it is) into a group of your own. You may
create new groups here as well (click on a
receiver first).
3. Modules read their sensors and transfer the
data periodically. Click on
Unlock sensor
settings tabs
at the bottom of the screen to
use the dials to set Use the dials to set the
Measurement
and
Transfer
intervals.
Set up operating limits and alarms
1. Go to the
Alarm settings
tab and click on
the
On/Off
buttons to enable alarms.
2. Set
Low
and
High
alarms as desired.
3. The
Delay
value determines how long the
system will wait, after detecting an out-
of-bounds condition on a sensor, before
triggering an alert to warn a person.
4. Click on
Close
when done and follow the
instructions on the screen.
5. See the user manual for more information
on this process in case you encounter any
problems.
F11
è
Sensor settings
tab for measurement and transfer intervals
F11
è
Alarm settings
tab to assign operating range limits and alarms
Thermo Scientific
Smart-Vue
™
2.0 Monitoring System
Move the
sensor into
your group
Set alarm
limits
Unlock settings
and set read and
transfer intervals
