4
Operation
Entering parameters
4-4
Multifuge X1R
Thermo Scientific
4. If available close the rotor with the rotor lid.
5. The display shows:
Entering parameters
Acceleration curve
The Multifuge X1R offers you a total of 9 acceleration and 10 braking curves with which samples
and gradients can be centrifuged.
After the centrifuge is turned on, the last running profile selected is shown.
1. Press the
key once in order to open the acceleration profile selection menu.
The display shows the message
Set acceleration
.
Braking curve
1. Press the
kay twice in order to open the braking curve selection menu.
The display shows the message
Set deceleration
:
Preselecting Speed / RCF
key.
1. Press the
Be sure to check all seals before starting any aerosol-tight applications.
See the information in the rotor instruction manual.
2. Select the desired profile by entering a digit between 1-9 on the numeric pad. Curve number 1 is
the slowest and curve number 9 the fastest.
3. Confirm your entry by pressing
.
2. Select the desired curve by entering a digit between 1-9 on the numeric pad. Curve number 1 is the
slowest and curve number 10 the fastest.
3. Confirm your entry by pressing
.
The display shows the
RPM
or the “RCF”-value depending on the display setting. Press the
key
to toggle between the two modes.
