Thermo Scientific LevelPRO, User Manual

Page: 46 / 128

Operation
Mode/Fault Alarm Setup
Figure 4-4. System Status
– The system level information provides details related to the hardware version,
firmware version and the number of available peripherals in the detector.
– The detector status gives details about firmware located in the RBP.
The only action the user may take on this screen dictates how the data will be viewed.
1. To capture new, updated information, click the Refresh button.
2. To have the information constantly updating on the screen, check the Auto
Refresh checkbox.
3. To exit the screen, click the Cancel button.
Mode/Fault
Alarm Setup
The purpose of the mode/fault alarms is to detect change in the alarm status and drive
the selected current or relay outputs based on the alarm action setup.
There are six Mode/Fault Alarm tabs.
Note:
The Mode/Fault Alarm Setup screens are organized slightly differently
within the detector. System and application alarm information are often
together on the same display screen. Reviewing the complete Mode/Fault
Alarm Setup map will aid in navigation of the keypad display.
– The System tab, shown in Figure 4-6 , allows the user to configure system-wide
alarms.
– The System Status tab, shown in Figure 4-7 , displays the alarms from the System
screen and shows whether or not the alarms are currently in an active state.
– The Application tabs (#1 - #4); shown in Figure 4-8 , allow the user to configure
application-specific alarms.
4
-
6 LevelPRO User Manual Thermo Scientific