4
Operation
Centrifugation
4-6
Heraeus Pico 17 / 21
Thermo Scientific
Run Time Preselection
1. Enter the desired value by pressing the key
below the display in the middle repeatedly, until
the desired value shows.
You can adjust the run time in steps of 1 min.
2. Press the
key to confirm the pre-selected value.
If you do not press any key, the display flashes for a few seconds The new preselected value is now
stored and the display shows the actual value.
Continuous Operation
1. Press the
key until
hd
is shown.
2. During continuous operation, the centrifuge will continue running until you stop it manually with
the
key.
Changing the settings during the run
You can change the settings during the run as follows:
1. Press one of the two
keys in the control panel.
The current value will switch into the pre-selecting value mode.
2. Enter the new value as described above.
3. Press the
key.
The value is taken over immediately.
Centrifugation
Once the rotor has been properly installed, the main switch has been turned on and the door has been
closed, you can start centrifuging.
Note
You can select a run time between 1 and 99 min or continuous operation.
CAUTION
Please note that the lifetime of particularly plastic rotor tubes is limited.
Continuous operation (extended use) may cause damage to them.
Summary of Contents for Heraeus Pico 17
Page 30: ...4 10 Heraeus Pico 17 21 Thermo Scientific 4 Operation ...
Page 51: ......
