13
Concentration Measurements—Advanced A-%T-C
Setting Up Test Parameters
54
GENESYS 10S Vis User Guide
Thermo Scientific
Setting Up Test Parameters
Y
To set up test parameters
1. Highlight the desired parameter.
Some parameters appear only if you select a concentration mode, while others appear
regardless of the selected measurement mode.
See
for a complete list.
2. When the parameters are set, press
Save Test
to save the test or
Run Standard
to measure
a standard (if in Conc/Std), or press
Run Test
(if in Conc/Factor).
Measuring a Standard
Y
To measure a standard automatically (using Auto 6 or Auto 3)
1. With Measurement Mode set to Conc/Std, press
Run Standard
.
2. Enter the concentration of the standard and press
Enter
.
3. Press
Measure Blank
.
4. Insert the blank and standard.
5. Press
Enter
to measure the blank and samples and display the absorbance and calculated
factor.
Y
To measure a standard manually (using Manual 6 or Single Cell Holder)
1. Press
Run Standard
.
2. Enter the concentration of the standard and press
Enter
.
3. Insert the blank and standard.
Summary of Contents for GENESYS 10S Vis
