Thermo Scientific Dionex, Operator'S Manual

Page: 125 / 228

9 • Troubleshooting
Doc. 065250-06 03/2020
113
This error occurs if the offset value is out of the expected range when the
pressure is being calibrated.
To troubleshoot:
1. Review the calibration procedure and then rerun the calibration (see
Section 10.10 ).
2. If the problem persists, contact Technical Support for Dionex products for
assistance.
This error occurs if the slope value is out of the expected range when the
pressure is being calibrated.
To troubleshoot:
1. Review the calibration procedure and then rerun the calibration (see
Section 10.10 ).
2. If the problem persists, contact Technical Support for Dionex products for
assistance.
This error occurs if the instrument method includes a command that specifies
a volume to be delivered by the dilution pump or loading pump (for example,
DilutionPump.DeliverVolume = 0.1 [mL] ), but the command is outside the
sample preparation command block. See “Notes” on page 92 for more
information.
To troubleshoot:
Move the command to inside the sample preparation command block.
–or–
Delete the command from the method.
Pressure offset calibration value is out of range
Pressure slope calibration value is out of range
Pump volume command must occur within
BeginSPSamplePrep/EndSPSamplePrep command block