Thermo Scientific Dionex ICS-5000, Operator'S Manual, Page: 379 / 482

9 • DC Service
Doc. 065342-06 12/11
363
on the end. A tubing cutter (P/N 049584) is included in the DC Ship Kit
(P/N 072011) . Refer to the instructions provided with the cutter.
•
For tightening requirements, refer to Installation of Dionex Liquid Line
Fittings (Document No. 031432). The manual is on the Thermo Scientific
Reference Library DVD (P/N 053891).
9.20 Connecting a Sample Loading Port to the Injection
Valve
1. For each sample loading port to be connected, locate the following items
in the DC Ship Kit (P/N 072011) :
•
One 1/4-28 fitting (P/N 052230) and ferrule (P/N 052231)
•
One 10-32 fitting (P/N 062980) and ferrule (P/N 062978)
•
0.75 mm (0.030 in) ID green PEEK tubing (P/N 052304)
•
One luer adapter fitting (P/N 024305)
2. Locate the metal release tab under the sample loading port on the front of
the DC (see Figure 9-31 ). Press up on the tab to release the port and pull
the port out the front of the DC.
3. Remove the fitting plug from the rear of the port.
Figure 9-31. DC Sample Loading Ports and Release Tabs
1
2
Sample Loading
Ports
Release Tabs
1 1
2 2