Thermo Scientific Dionex AutoTrace 280, Operator'S Manual

Page: 145 / 166

B • Installation
Doc. 065330-05 03/2020
137
B.3.3 Connecting the Exhaust Hose
If the eluted solvents need to be vented, use the system's internal fan to
safely vent solvent vapors. To connect the system's exhaust hose:
1. Connect the exhaust hose (P/N 071090) to the system's exhaust port
by sliding and rotating the hose onto the port (see Figure B-11 ).
Figure B-11. Exhaust Port
2. Route the hose to a suitable vent location. If necessary, use wire
cutters or scissors to cut any excess hose.
B.3.4 Connecting the Gas Supply
To connect the gas supply to the system's gas inlet:
1. Locate the 3-m (10-ft) length of 1/8-in ID x 3/16-in OD tubing
(P/N 070379) and the 1/8-in quick-disconnect fitting in the Ship Kit
(standard Dionex AutoTrace 280, P/N 071383; Dionex AutoTrace
280 PFAS, P/N 22136-62005).
2. Push the barbed end of the fitting into one end of the tubing (see
Figure B-12 ).
Exhaust
Port