Thermo Scientific Differential Pressure Sensor, Supplemental User Manual

Page: 22 / 35

18 | CO
2
, Temperature and Humidity Smart Sensor Compatible Sensors for Smart-Vue Pro Duo / Quatro Data Logger
CO
2
, Temperature and Humidity
Smart Sensor
Overview
The CO
2
, temperature and humidity Smart Sensor is a triple-
function device with three sensors. This Smart Sensor is
designed to be placed upright inside an incubator and
connected via the provided ribbon cable to a Smart-Vue Pro
data logger placed outside the incubator.
Figure 21. Ribbon cable connecting to sensor unit
inside incubator
The complete kit is shown here (Smart-Vue Pro data logger
sold separately):
Figure 22. Complete CO
2
, Temperature and
Humidity Sensor Assembly
The various components in the Figure 22 are as follows:
CAUTION: Do not place the data logger inside
the incubator. Remove the CO
2
, temperature and
humidity sensor from inside the incubator during
decontamination procedures (which may expose
the sensor to damaging heat/environment).
CAUTION: Failure to remove sensor from
incubator during decontamination cycle will
result in damage to the sensor, requiring
complete sensor replacement, and is not
covered under warranty.
Table 1. Description of
Figure 22
S. No Description
1
AC adapter, provided with several international
plugs.
2
USB charging cable, plugged into AC adapter
on left-hand side of
Smart Sensor extension.
3
Smart Sensor extension cradle, connected to
the bottom of the
Smart-Vue Pro data logger.
4 Smart Sensor extension connector cable.
5
Triple CO
2
, temperature and humidity sensor.
6
USB junction cable from Smart Sensor
extension providing power to Smart-Vue Pro
data logger.
7
4-wire flat ribbon cable to connect sensor with
Smart Sensor extension.
1
2
3
4
6
5
7