Thermo Scientific Agilent 1100 Series, Getting Connected Manual

Page: 29 / 32

Thermo Scientific Agilent 1100 Series Getting Connected Guide for LC Devices 19
6
Upgrading an HP 1100 Series LC
The Xcalibur data system supports control of the Hewlett-Packard (HP) 1100 Series LC only
if you upgrade the HP 1100 communication interface to an Ethernet interface.
 To upgrade your HP 1100 Series LC
1. Order the appropriate upgrade parts from your local office for Thermo Scientific San Jose
products:
• If the HP 1100 is not interfaced to a mass spectrometer as an Xcalibur-controlled
GPIB inlet device, order the JetDirect Ethernet Control Kit. This kit contains the
parts listed in
Table 5 .
• If the HP 1100 is interfaced to a mass spectrometer as an Xcalibur-controlled GPIB
inlet device, order the parts listed in Table 6 .
Table 5. JetDirect Ethernet Control Kit (P/N OPTON 30018)
Description Part number
10/100 Autosensing 8-port Ethernet switch 00825-01-00024
Contact closure PCB 00012-27714
Ethernet 10 Base-T cable (2) 00012-70008
External contact closure cable 00012-27716
HP JetDirect 400N PCB 00825-01140
Note For an HP 1100 LC system that currently interfaces with an MS detector as
an Xcalibur-controlled GPIB inlet device, you should have already installed the
contact closure PCB and the external contact closure cable. As a result, order only
the parts specified in
Table 6 .
Table 6. Parts required to upgrade an Xcalibur-controlled HP 1100 Series LC
Description Part number
Ethernet 10 Base-T cable (2) 00012-70008
Ethernet switch 00825-01-00024
HP JetDirect 400N PCB 00825-01140