Thermo Scientific Agilent 1100 Series, Getting Connected Manual

Page: 22 / 32

3
Specifying the TCP/IP Settings and the BCD Board Location
Specifying the TCP/IP Settings
12 Agilent 1100 Series Getting Connected Guide for LC Devices Thermo Scientific
5. Select the Contact Board Installed check box.
6. Do one of the following:
• If you have not already specified the TCP/IP settings for the Agilent 1100 Series
stack, leave the General page open and go to the next procedure.
• If you have finished specifying the configuration options for the stack, click OK to
save the settings and close the dialog box. Click Done to exit the Xcalibur Instrument
Configuration window. Open the Xcalibur data system before you turn on the
devices of your Agilent 1100 Series LC stack.
Specifying the TCP/IP Settings

To specify the TCP/IP settings for the Agilent 1100 Series stack
1. From the Instrument Configuration window, open the General page for the autosampler
( Figure 9 ).
Figure 9. General page of the Agilent 1100 AutoSampler dialog box
Note When you select the Contact Board Installed check box, the Timed Events page
appears in the Instrument Setup view for the autosampler. See Chapter 4, “Triggering
Data Acquisition.”
12-digit hexadecimal
number located on the
back of the HP JetDirect
network card