2
Accela 600 Pump or Accela 1250 Pump Installation
Back Panel Connections
Thermo Scientific
Accela 600 and 1250 Pump Hardware Manual
17
Back Panel Connections
To operate the Accela pump from the data system computer, connect the power cable and the
USB communication cable. To operate the Accela pump as part of an Accela LC system,
connect the interconnect cable that coordinates the operation of the pump with the other
Accela modules
.
shows the back panel of the Accela 1250 Pump.
Figure 5.
Back panel of the Accela 1250 Pump
CAUTION
Never connect the Accela pump to an electrical line source that has power
drops or fluctuations of 10% below the nominal rated line voltage.
355 River Oaks Parkway
S
an Jose, CA, U.
S
.A
This device complies with FCC Rules, Part 15.
Operation is subject to the following conditions
(1) This device may not cause harmful interference,
and (2) This device must accept any interference
received, including interference that may cause
undesired operation.
This product is manufactured under, and covered
by, one or more of the following U.S. patents:
CAUTION
REFER ALL SERVICE
TO QUALIFIED
PERSONNEL ONLY
DISCONNECT INPUT
POWER BEFORE
OPENING COVER.
RESER
VED
RESER
V
ED
GND
GND
INJECT
HOLD
PUMP
READY
GRAD. ST
AR
T
5V
USB
D-SUB25
Model: 1250 Pump
Serial No: 925000
DO NOT COVER
RS232
5,653,876
6,248,157 B1
Futher patent pending
1 2 3 4 5 6 7 8
DO NOT USE
TOGETHER
WITH
D-SUB25
Line
Fuse
100V - 240V
50/60 Hz
2x T2.0A/250V
220VA
!
!
EP 2107241A2
USB series B socket
Interconnect cable socket
for a system with an
Accela Autosampler
RS-232
connector
D-sub 25-pin connector
(accepts the start signal
from an Accela Open
Autosampler)
Power line
receptacle
