Thermo Scientific 5028i, Instruction Manual

Page: 231 / 330

System Description
I/O Components
Thermo Fisher Scientific Model 5028
i
Instruction Manual 8-11
Table 8–1.
RS-232 DB9 Connector Pin Configuration
DB9 Pin Function
2 RX
3 TX
7 RTS
8 CTS
5 Ground
The instrument uses a four wire RS-485 configuration with automatic
flow control (SD). Refer to Table 8–2 for the DB9 connector pin
configuration.
Table 8–2. RS-485 DB9 Connector Pin Configuration
DB9 Pin Function
2 + receive
8 - receive
7 + transmit
3 - transmit
5 ground
An RJ45 connector is used for the 10Mbs Ethernet connection
supporting TCP/IP communications via standard IPV4 addressing.
The IP address may be configured for static addressing or dynamic
addressing (set using a DHCP server).
Any serial port protocols may be accessed over Ethernet in addition to
the serial port. Up to three simultaneous connections are allowed per
protocol.
The external accessory connector is not used in the Model 5014 i
analyzer.
This port is used in other models to communicate with smart external
devices that may be mounted hundreds of feet from the analyzer using
an RS-485 electrical interface.
RS-485 Connection
Ethernet Connection
External Accessory
Connector